print raft (yes/no) Do you want to print raft. If this is not checked then only the calibration object will be printed (good for PLA or ABS on hot bed)
print triangle (yes/no) If checked the test object will be triangle so you can also check if diagonal line (45deg) width is ok (some firmware's have error and diagonal lines move 1.4 times faster then straight X or Y lines). If unchecked the test object will be square.
raft base speed (mm/sec) Head speed for the raft base layer
raft interface speed (mm/sec) Head speed for the raft interface layer
object speed (mm/sec) Head speed while printing the test object raft base extruder speed (rpm) Extruder speed (in g-code the value will be written after this value is multiplied by 10) while printing base raft layer
raft interface extruder speed (rpm) Extruder speed (in g-code the value will be written after this value is multiplied by 10) while printing interface raft layer
object extruder speed (rpm) Extruder speed (in g-code the value will be written after this value is multiplied by 10) while printing object layer thickness (mm) thickness of the layer object is printed with how many layers the test object height will be "how many layers" * "layer height"
raft base temp (C) temperature raft base layer is printed at
raft interface temp (C) temperature interface layer is printed at
object temp (C) temperature test object is printed at