AUX locations and pinouts on RapMan 3.2 PCB

2 replies [Last post]
pej02
Offline
Joined: 2013-03-12
Posts: 1
Points: 2

Whereabouts are the AUX1 and AUX2 ports on the PCB and what is the logic sequence for them when controlled by the M2xx g-code commands?

Also, there is a port labelled AUX on the bottom left of the PCB. What can it be used for (and what does a typical electrical circuit connected to it look like?) and how can it be controlled via g-code commands? I've sent various M-commands to try and control it from this Wiki command list but it is always +12Vdc regardless.

anselnobel
Offline
Joined: 2013-03-22
Posts: 1
Points: 1

Electric sign markings mean power is made​​.  Electric sign is made ​​of different kinds. Electric sign is our guide differently. There is also become electric sign board. There are various ways we work. Sign board that we use for advertising. And is used for advertising your business. The Business Signs is moving at a very early development remain. Information reaching people through advertising is the business. When the people have started taking interest in the business.

waltorg
Offline
Joined: 2013-03-23
Posts: 19
Points: 19

Great question,

 

I was wondering about those ports to control other devices or send notification during prints.

Let me take a closer look at the board in the next few days.

 

W